UNINET Select DTF Warm/Cold Peel Transfer Film Roll – 17 in x 328 ft (430mm x 100m)
UNINET® Select DTF Warm/Cold Peel Transfer Film Roll – 17 in x 328 ft (430mm x 100m)
UNINET™ Select DTF Warm/Cold Peel Transfer Film Roll – 17 in x 328 ft (430mm x 100m)
UNINET™'s own Select DTF Roll is a warm/cold peel, with superior vibrancy compared to other competitive brands.
Compatible with most DTF printers 17" or wider.
Additional Information about Uninet Film
Recommended temperature for DTF powder curing in a heat station:
• A3 sheets – 120°C / 250°F for 120 seconds. For sheets with large images and / or a lot of ink coverage, it may be
necessary to open the cover, rotate the page 180 degrees, and then bake again for another 2 mins.
• A4 or smaller sheets - 120°C / 250°F for 120 seconds
Application to substrate:
• Recommended Heat Press Pressure: Medium or 60 lbs of pressure
• Place or thread your garment on the press. Position the transfer sheet (print side down) onto the garment. Cover
the transfer sheet and garment with kraft paper and close the press, using the following suggestions:
COTTONS and BLENDS:
• Press at 300 - 325°F for 10 – 12 seconds
• Remove from press and let cool for 1 minute, then peel
• Place back on the press, cover with kraft paper or a T.Seal and post press for 5 – 10 seconds
Hoodies may require 325°F and up
POLYESTERS / TRI-BLENDS:
• Press at 265 – 275°F for 8 – 10 seconds
• Remove from press and let cool for 1 minute, then peel
• Place back on the press, cover with kraft paper or a T.Seal and post press for 5 – 10 seconds
Thinner material may require lighter pressure; otherwise the transfer can leave a ‘window’ on the garment and/or
scorching may occur.
Polyester settings can vary, but best to use lower temperature and pressure generally
50 / 50:
• Press at 275°F for 12 seconds
• Remove from press and let cool for 1 minute, then peel
• Place back on the press, cover with kraft paper or a T.Seal and post press for 5 – 10 seconds
COTTON:
• Press at 310 - 325°F for 15 seconds
• Remove from press and let cool for 1 minute, then peel
• Place back on the press, cover with kraft paper or a T.Seal and post press for 10 seconds
FINISHING:
• Matte finish – Kraft paper, T.Seal or parchment cover sheet.
• Shiny/gloss finish - Teflon cover sheet
Specialty silicone pads with texture can be used to prevent gloss look, gives print a nice textured feel.
ADDITIONAL SUGGESTIONS:
• Thicker fabrics require more heat, generally.
• Hats (poly) may require 245 - 250°F for 5 - 8 seconds
• Umbrellas, EZ-ups, stadium chairs will require testing and trial and error.
Be careful of dye / ink migration with polyester textiles - perform a 24hr test (fine tuning) to see if the ink
migrates (clothing dye reacts with the DTF ink)
GARMENT TYPES:
• DTF works with almost all fabrics and garment types:
• Combed Cotton, Ring Spun Cotton, Organic Cotton, Polyesters, Blended Fabrics, Poly-Cottons,
Tri-Blends, Polyester-Spandex, Leather, Vinyl, Denim, Canvas and much more.